EarthQuaker Devices Night Wire Harmonic Tremolo

EarthQuaker Devices - Night Wire Harmonic Tremolo

The Night Wire is a feature-rich harmonic tremolo. What is harmonic tremolo? In short, the signal is split into high pass and low pass filters, then modulated with an LFO that is split 180 degrees.

The Night Wire takes the traditional harmonic tremolo a few steps further by allowing the center point of both filters to be adjusted for different tones. The filter frequency has three modes: Manual, LFO and Attack. In Manual mode, the center point can be set to a fixed position with the frequency control. In LFO mode, the filters are continuously swept and the frequency control adjusts the speed. In Attack mode, the filters are dynamically swept according to pick attack and the frequency control acts as a range control, much like a standard envelope filter. The tremolo section has two modes, Manual and Attack. In Manual mode, the speed of the tremolo is governed by where the rate control is set. In Attack mode the speed is controlled by pick attack and the rate controls the sensitivity; the harder you pick, the faster the rate and vice-versa. The tremolo can be subtle and shimmery or full-on throbbing depending on where the depth control is set. With the depth set to zero, the Night Wire will act like a fixed filter, phase shifter or envelope-controlled filter depending on which mode the filter frequency is in. It also features a cut/boost volume control to get your levels just right. Each Night Wire is handmade one at a time in the moonlit village of Akron, Ohio.

This device is true bypass and uses relay based “soft touch” switching. Audio will not pass without power.

Features

Controls

Rate Toggle: This toggle lets you select between two ways to control the speed of the tremolo. Attack lets you adjust the speed by pick attack. In this mode, the Rate knob controls the sensitivity of the dynamic tremolo. The higher the rate and harder you pick, the faster the speed will rise and vice versa. In Manual mode, the Rate control adjusts the speed like a common tremolo.

Frequency Toggle: This toggle lets you select one of 3 different ways to control the center frequency of the filter section. In LFO mode, the frequency is continuously swept by an LFO. In this mode, the Frequency knobs adjusts the speed of the LFO. In Manual mode, the frequency is determined by where the Frequency knob is set. In Attack mode, the center frequency is dynamically controlled by pick attack and the Frequency knob adjusts the sensitivity.

Level: Sets the output level, unity is around noon.

Depth: Adjusts the depth of the tremolo. More clockwise, less counterclockwise. When fully counterclockwise, the amplitude modulation will be removed and the Night Wire will function as a fixed filter, envelope controlled filter or phaser depending on where the frequency toggle is set.

Rate: In manual mode, this controls the speed of the tremolo. Faster speed clockwise and slower speed counterclockwise. In Attack mode, this controls the sensitivity of the dynamic tremolo. The higher the rate and harder you pick, the faster the speed will rise and vice versa.

Frequency: Controls the center frequency of the filters in manual mode: higher clockwise, lower counterclockwise. In LFO mode this controls the rate of the sweep: faster clockwise

Specs

Dimensions: 4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
Current Draw: 65 mA
Input Impedance: 1 MΩ
Output Impedance: <1 kΩ

Flexi-Switch® Technology
This device features Flexi-Switch® Technology! This relay-based, true bypass switching style allows you to simultaneously use momentary and latching style switching.

For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass.

For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you release the switch the effect will be bypassed.

Since the switching is relay based, it requires power to pass signal.

Power
This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise.

DO NOT RUN AT HIGHER VOLTAGES!

Shipping Policy

Flipside Music ships items within 2 days of purchase. UPS, FedEx or USPS will be the parcel carrier used to ship your purchase, if you have a preference for another shipping service provider, please contact Ike or Dylan and we will work with you and the company you choose.

International orders may be subject to destination countries sales, VAT or import tax. Please contact your country's duty center, prior to purchase for more information regarding these fees. Flipside Music will not reduce listed price to avoid said duties, taxes, or export/import fees.

Return Policy

New Items:

We honor a 14 day return window on all new items.

If you feel the need to return an item, it must be in the sellable condition, no paint chips, scratches or broken parts. Sellable Condition means that the product(s) is in exactly the same condition as it was when you received it. The item must have all the original packaging, included accessories owner’s manuals and blank warranty card, no sign of wear or abuse.

Used and Vintage Gear:

We honor a 3 day return window on all used and vintage items.

All our used gear is tested for functionality prior to being available for purchase and therefore only carries a 3 day approval period. If you would like to make a return just let us know within the 3 day window.

Damaged or Defective Items:

We visually inspect all items before shipment. If you believe you have received a damaged or defective product, please contact us immediately so we can work through the issue. Guitars, basses, and other equipment returned to us with pick marks, "buckle-rash", or any other damage or evidence of use may be subject to a 20% restocking fee, repair charge or disqualification of return. All items must be returned to us in the same condition they were when shipped to qualify. We reserve the right to refuse any return if we determine the item has been misused, modified or damaged by the purchaser. If the item turns out not to be defective upon inspection, we will have to deduct the cost of shipping from your return credit.

Shipping Charges incurred through the return of an item:

You will be responsible for the shipping charge for the return of your item, and if your item qualifies for Free shipping on its way to you, this shipping charge will also be deducted from your refund. If your item is determined to be defective, we will pay the shipping charge, equivalent to ground service.